Home > Products >

Ricmotech Hard-Mount Adapter for T150 and TMX Wheels

Hard-Mount adapter for T150 and TMX wheels


 
Alternative Views:


Your Price (USD): $24.95
Compatibility: T150 and TMX Wheels


Item #: RMT-T150HMP

Description
 

This is a simple device to hard mount the Thrustmaster T150 or TMX wheel bases to a wheel stand or a racing cockpit with screws. Thrustmaster designed these wheels to be clamp-on only. Under use the clamp works its way loose during racing. This adapter solves this problem. The adapter simply bolts to your wheel stand or racing cockpit using the pre-drilled holes for Thrustmaster wheels (most stands and cockpits have these holes). The wheel then interlocks perfectly with the adapter and a single screw locks them together. This is a perfect solution for broken Thrustmaster wheel clamps on these wheel bases. These hard mount points are located in the same spot as the ones for the other Thrustmaster wheels. Bottom line, this is a simple solution to a simple problem.

This hard-mount adapter is designed for the T150 and the TMX racing wheels. This is not intended to fit any other wheel bases.

Features
  • Made from solid industrial polyethylene
  • Mounts to predrilled Thrustmaster holes on most rigs
  • Includes screws and instructions

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 80 Write a review »

  0 of 0 people found the following review helpful:
 
4 of 5 September 23, 2019
Reviewer: Jacob Nelson from Kyle, TX United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
3 of 5 Provides hard mount, but the nut is intrusive August 27, 2019
Reviewer: Joshua Dolim from Shoreline, WA United States  
Appears to be 3D printed out of material that is up to the job. Not terribly heavy, and relatively easy to install (though be careful of the nuts that attach the hard mount to your rig as they can push up and then turn as you try to screw them in).

I was hoping to be able to use the hard mount surface from this thing to be able to mount my wheel somewhere other than the front-most position on my playseat challenge, but the mounting nut sticks out a half inch below the bottom of the adapter, forcing me to use the front-most position only. The only advantage to using this over the clip is that it's a bit more stable, but oddly enough the clip was also holding the mounting plate a little more firmly than the standard clamp on the playseat challenge does, so it actually wobbles more.

This would be an easy 5/5 if the nut were recessed.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 August 13, 2019
Reviewer: Stephen Johnson from Maple Valley, WA United States  


Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Love it. August 9, 2019
Reviewer: David T Hess 3rd from Kapolei , HI United States  
I have a wheel stand pro and it just makes everything so much more stable!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
2 of 5 Does the job okay July 28, 2019
Reviewer: Hayden Evans from Las Vegas, NV United States  
Hard mounts the wheel as advertised but the thread inserts that go into the wheel to be used for the screws to tighten into come loose after a few days use. Glue or some tape is needed to keep the wheel tight to the wheel plate mount

Was this review helpful to you?

View All Customer Reviews