I bought the interface board as I have a load cell conversion. This interface board is only needed if using the LC27 v2 load cell kit on a set of Logitech........ The adapter and board duly arrived and I fitted them both according to the instructions.. Clutch ok, throttle ok, no brake. Even worse, hitting the brake gave me throttle. The seemed like a wiring issue/short so I made sure i put everything in the right place and tried again. Same thing in the calibration software. I then spent 2 hours stripping back wires to make sure there were no shorts and resoldering all connectors. Still the same. Next day I called ricomotech, (not cheap from the UK). The guy I spoke to who's name I unfortunately didn't get was very helpful and instructed me to remove the interface board and make a small wiring change. This fixed the issues straight away. So basically to sum it up, I paid 4.95 for a board I didn't need that cost about 4 hours of looking for a problem the board created.
Reviewed by: Paul Hance from Aberdeen, Scotland United Kingdom on 3/26/2016 1:41:00 PM